Installation Tool for Slip-Over Floor Savers
This handy tool is used to install Slip-Over Floor Saver felt-bottom furniture pads onto classroom style chair and table legs. The Slip-Over Tool is a small metal tool with two prongs and hooks on each end that slip into the round flexible opening of the furniture glide to open it enough to then slide the cover onto the chair leg while squeezing the tool after placing it to remove it from the installed floor saver glide.
Steps for use are as follows:
- Squeeze the Slip-Over installation tool and insert hooks into the opening of the Slip-Over pad. Stop squeezing the tool and it will stretch the pad opening.
- With the top of the Slip-Over pad stretched open, slide it over furniture glide.
- Hold the furniture so it doesn’t move when you pull back and up with the tool to stretch the Slip-Over pad around the foot of furniture leg. While executing this motion, begin to squeeze the tweezer-like tool.
- In a fluid motion, you’ll remove the tool, while still squeezing, out of the glide by pushing it towards the furniture leg. This will cause it to disengage.
Questions regarding the use of floor protectors and how to determine the best felt-bottom pad for your furniture to protect your hard surface flooring, call 1877FloorGuy for guidance at 877-356-6748 or send an email inquiry to firstname.lastname@example.org.