Hilway Direct PLUS Floor Finish/Cleaner-Maintainer, 33.8 Ounce (1L)

An all-in-one low-sheen floor finish and cleaner-maintainer to clean, finish and refresh resilient floors, including VCT, LVT, sheet vinyl and rubber. Hilway Direct PLUS Floor Finish & Cleaner/Maintainer in a 33.8 oz bottle cleans and revitalizes the floors, leaving behind a hard-wearing, acrylic finish that resists scuffs and scratches. Hilway Direct Plus contains low VOCs and is non-hazardous. Use this cleaner-maintainer full strength for initial floor finish application and diluted for routine cleaning that restores finish on the floor.

Coverage for single coat: 350 square feet per liter. Proper application requires two (2) coats. Coverage may vary depending on porosity of flooring material.

• Also available in 1-gallon and 5-gallon containers
• high solids
• Low sheen
• Non-hazardous
• Safety Data: Hilway Direct Plus Floor Finish & Cleaner/Maintainer MSDS
• Instructions: Instructions for Hilway Direct Plus
• For Use On: Vinyl (sheet, VCT, LVT), Rubber, Linoleum, Cork, Marble, Slate, Quarry Tile, Terazzo, Concrete, Asphalt Tile.

Directions For Use:
Initial Application:

1. Clean floor thoroughly prior to application of finish. For floors with a factory finish, remove finish following flooring manufacturer's instructions. Rinse thoroughly with water after removing old coating to neutralize.
2. Shake finish well then let it settle 5 minutes before use.
3. Apply a thin, even, undiluted coat using a microfiber applicator mop.
4. Apply 2-3 coats, allowing each coat to air dry completely (approx 30-60 minutes) between coats.
5. Allow finish to dry for at least eight (8) hours after the second coat and before use.

Daily Cleaning, Mop & Bucket:

1. Sweep floor to remove loose dirt.
2. Dilute 1oz Hilway Direct Plus per 1 gallon warm water.
3. Mop floor with diluted cleaning solution using a 2-bucket system. Use clean water in 2nd bucket to rinse mop.
4. Pick up excess solution with a tightly wrung-out mop.
5. Allow floor to air dry. Do not rinse floor after cleaning.

Daily Cleaning, Auto Scrubbing Machine:

1. Sweep floor to remove loose dirt.
2. Dilute 1oz Hilway Direct Plus per 1 gallon warm water.
3. Scrub floor with diluted cleaning solution.
4. Trail mop excessive wet areas behind scrubber.
5. Allow floor to air dry. Do not rinse floor after cleaning.

Notes:

• Do not use a treated mop for application.
• When applying the product avoid strong sunlight and drafts.
• Turn off under floor heat before commencing work.
• Ensure sufficient ventilation.
• Read complete product label and manufacturer instructions prior to application.