Laticrete Stonetech BulletProof Sealer, 1-Gallon

Laticrete (DuPont™) StoneTech® Professional BulletProof® Sealer, 1 Gallon

Advanced penetrating microbond protection

Maximum protection against most stains

Makes cleaning stone easier

Preserves natural look

Water-based low-solids coating

Interior & exterior

For Use On: Natural stone such as marble, granite, limestone, bluestone, saltillo, travertine & sandstone. Best suited for the most porous stone surfaces. Indoor and outdoor stone surfaces.

Directions for Use: Read entire product label prior to use. Always test in a small inconspicuous area with a 24-hour cure time to determine ease of application and desired results.

1. Mask any surfaces not intended to be treated.
2. Liberally apply an even coat using a paint pad, roller or brush. DO NOT APPLY PRODUCT WITH SPRAYER.
3. Allow sealer to penetrate the surface for 15 - 30 minutes. During this time, distribute sealer over entire area to ensure even penetration. Remove excess sealer by wiping entire surface thoroughly with clean, dry towels.
4. A second coat may be needed for porous, absorbent surfaces and should be applied 30 - 40 minutes after initial application as directed in steps 2 - 3.
5. 15 - 30 minutes after final application, wipe entire surface with clean dry towels to remove any excess sealer. To remove residue, reapply a thin coat of sealer, allow to dwell for 2 - 3 minutes, agitate with a white nylon pad and dry thoroughly with clean, dry towels.
6. A full cure is achieved after 24 to 72 hours; foot traffic may begin in 6 to 8 hours. If foot traffic must resume sooner, cover the floor with red rosin paper to protect it until full cure has been achieved.
7. Clean tools with water.

Notes:
Allow new grout installations to cure for a minimum of 72 hours prior to application.
Make sure surface is clean and free of waxes and coatings prior to application.
Sealer may be applied to damp surfaces one hour after standing water has been removed.
Surface temperature should be between 50-degrees and 80-degrees Farenheit.
Ensure that the area is well-ventilated during application and until the surface is dry.

Coverage: Gallon: 50 - 400 sq ft depending on porosity of the stone surface.
Expected Wear: 3 to 5 years on interior surfaces & 1 to 3 years on exterior surfaces.

Safety Data Sheet for DuPont™ StoneTech® Professional BulletProof® Sealer.

Additional Information: Clean surface as needed with Revitalizer® Cleaner & Protector or Stone & Tile Cleaner.