Hilway Direct Floor Finish GLOSS/HIGH-GLOSS, 1.33 Gal

Item Number: HD-G133
1 - 3 pieces$43.00 ea.
4 + pieces$38.70 ea.
Regular price:$43.00
Quantity:



Hilway Direct Floor Finish GLOSS/HIGH-GLOSS, 1.33 Gallons

Classic high shine Acrylic floor finish. Hard-wearing, durable protection. Highly scratch & scuff resistant. No VOCs. Non-Hazardous. High-shine.

For Use On: Sheet Vinyl, LVT, VCT, Rubber, Linoleum, Cork, Asphalt Tile, Marble, Slate, Concrete, Quarry Tile, or Terrazzo flooring.

Directions For Use:
  1. Sweep or vacuum then clean floor thoroughly or remove existing floor finish coating as applicable. Rinse and neutralize floor with clean water.
  2. Shake Hilway Direct finish well before use.
  3. Apply length-ways a thin, even, undiluted coat using a wide mop or applicator.
  4. When sufficiently hard to walk on, approximately one (1) hour, repeat the procedure crosswise.
  5. Apply up to 3 coats total.
  6. Allow finish to dry for at least eight (8) hours after the final coat and before use. Finish should be completely dry before allowing traffic on floor.
Notes:
  • When applying the product avoid strong sunlight and drafts.
  • Turn off under floor heat before commencing work.
  • Ensure sufficient ventilation.
  • Read complete product label and manufacturer instructions prior to application.
  • Dry time will vary depending on ambient conditions including temperature and humiditiy.

  • Coverage: Single Coat: 1500-2000 square feet per 1.33 gallon container. Proper application requires two (2) coats. Coverage may vary depending on porosity of flooring material.

    Recommended Cleaning & Maintenance:
    Dust mop or sweep then clean with a mop or automatic scrubber using Hilway Direct Neutral Cleaner.

    Safety Data: Hilway Direct Gloss Floor Finish MSDS